Old cast iron and steel boilers were often covered in asbestos block, hard cement jackets and wrapped breeching to the chimney. We clear boiler rooms in homes, two-families, apartment buildings, churches, schools and factories across Central New York.
Price within 1 hour.
Before about 1980, a boiler was often insulated by hand on site. Installers stacked rigid asbestos block insulation against the sides and top, then troweled a hard white or gray cement over it to make a smooth shell. That shell is what most people mean by an asbestos boiler jacket. It can look like plaster, sometimes painted silver or tan, sometimes cracked with chunks missing at the corners.
Newer boilers from the 1950s onward usually came with a factory sheet metal cabinet, but the inside of that cabinet can hold asbestos paper, rope gaskets around the doors and insulation board. The breeching, the large flue pipe running from the boiler to the chimney, was frequently wrapped in the same block and cement. Owners call all of this boiler wrap or boiler plaster.
Syracuse has a lot of big steam boilers sitting in basements that were built for coal and later converted to oil or gas. You find them in 1910s and 1920s two-families in Westcott, the University Hill area and Elmwood, in brick apartment blocks downtown, and in Victorian houses in Skaneateles, Cazenovia and Auburn. Many of these units are the size of a small car and wrapped from floor to flue.
Churches, parish halls and schools from the same era tend to have a dedicated boiler room with two or more units, a long run of insulated breeching and wrapped steam headers overhead. Mills and factory buildings in Oswego, Fulton, Seneca Falls and Utica can have even larger setups. Farmhouses out in Cayuga and Madison counties sometimes have a single smaller boiler in a fieldstone cellar with a low ceiling.
The usual starting point is a dead or failing boiler. The heating contractor quotes a new high-efficiency unit, then sees the wrapped shell and tells the owner the old one cannot come out until the asbestos is gone. Most heating contractors and scrap haulers will not cut up or move a boiler covered in that material, so the job waits on abatement.
Other owners call after a home inspection during a sale, or when an insurer or lender asks about the old boiler in the basement. Some want to convert a steam system to hot water or forced air and need the whole boiler room cleared. Landlords call when an apartment building's old unit is replaced, and owners of closed churches or schools call before a sale or a demolition. A boiler with crumbling insulation should be left alone and not disturbed.
We do not inspect, test or sample. If you already have a lab result or an asbestos survey of the building, send it along. Without one, we price the boiler insulation as presumed asbestos-containing. With an old boiler that is coming out anyway, that is usually the simplest way to get the job moving.
The right photos make a quick and accurate price possible. Take a wide shot of the whole boiler from a few steps back, a shot of the breeching all the way to the chimney, and close-ups of any damaged areas. Put a person, a door or a tape measure in one photo so we can judge the size. Send these and we reply with a price within 1 hour, 7 AM to 9 PM ET.
A small residential boiler with a sheet metal cabinet can be a few hours of work. A large steam boiler with a full cement jacket, plus its breeching, is commonly a day or a few days. Commercial boiler rooms with several units take longer. Our DOL-certified crew seals the boiler room off from the rest of the building, and the rest of the property stays in use.
The insulation is stripped, bagged and hauled to a permitted landfill. If you want the boiler gone, we remove it after the insulation is off, which lets the steel and iron go out as scrap. The required state notices for the job are ours to file. When we leave, the boiler room is either bare boiler and pipe for the heating contractor or an empty space with capped lines. You receive copies of the waste manifests.
Most boiler work is for homeowners and landlords, from one-family houses in Geddes and Salina to multi-unit buildings in Utica and Binghamton. Buyers and sellers call to clear an inspection item before closing. Small jobs are welcome, including one boiler door gasket, one section of breeching or a single small boiler in a cellar.
Plumbing and heating contractors bring us in so they can set the new unit. Property managers call for apartment complexes and office buildings. General contractors use us ahead of interior renovations, and commercial owners call for churches, schools, warehouses and plants with old boiler rooms that have been shut down. The process is the same for each: send the address and photos, get a price back in 1 hour.
With the old boiler and its insulation out, the heating contractor can set a new unit, often a much smaller wall-hung or floor model, and run new venting. Many owners use the open space to add a laundry area or storage once the large steam unit and breeching are gone. Pipes that stay get a clean starting point for new insulation.
If the building is coming down, we also do demolition, so abatement and teardown are one company on one schedule. That matters for vacant churches, closed schools and old factory buildings where the boiler room is just one part of a larger job. The asbestos comes out first, and the demolition follows under the same contract.
We are based at 4830 W Seneca Turnpike in Syracuse and work throughout Syracuse and Onondaga County, including East Syracuse, North Syracuse, Minoa, Camillus and Lysander. Outside the county we take jobs in Oswego, Cayuga, Cortland, Madison, Oneida, Seneca, Wayne and Jefferson counties, and around Rochester, Utica, Binghamton, Watertown and Elmira. Send the address and photos, or call (315) 810-9558, and we will get back to you with a price in 1 hour.
The price for boiler work depends on the size of the boiler, how much of it is covered, and whether the breeching and nearby piping are part of the job. Access matters a lot: a boiler reached by a wide bulkhead is easier than one down a narrow stair or in a low fieldstone cellar. Taking the whole boiler out adds to the work, while stripping insulation and leaving the unit for the heating contractor costs less.
Typical figures for common asbestos jobs in Central NY:
| Job | Typical cost |
|---|---|
| Smallest jobs: one pipe run, one section of duct, one room | From about $1,250 |
| Floor tile and mastic, one room | $1,500 to $4,500 |
| Pipe insulation | $2,000 to $8,000 |
| Ductwork or duct wrap | $2,000 to $8,000 |
Send the address and a few photos. Estimate within 1 hour, 7 AM to 9 PM ET.