Sprayed fireproofing on steel beams, columns and the underside of metal deck, in fluffy or hard cement form. We remove it from offices, schools, stores, warehouses and plant additions across Central New York.
Price within 1 hour.
Asbestos fireproofing is a coating that was sprayed or troweled onto structural steel to slow the heat of a fire reaching the frame. It went on from the 1950s into the 1970s, mostly in steel-frame buildings. Depending on the mix, it looks like gray or off-white cotton candy, a lumpy stucco, or a hard crust a little like cement. People call it spray-on fireproofing, fluff, beam coating, sprayed asbestos insulation, or SFRM on the drawings.
Not every sprayed coating from those years contains asbestos. Some products used mineral wool, gypsum or cement instead, and the soft, fibrous mixes are the ones that commonly do. Older buildings are often patched with newer material, so a single floor can carry two or three different products. Fireproofing that is hanging in strands, falling onto ceiling tiles or crumbling at a touch should be left alone and not disturbed until it is removed.
In Syracuse it shows up in mid-century office buildings downtown and along South Salina Street, in medical offices on University Hill, and in flex and warehouse space around Carrier Circle and East Syracuse. Schools built or added onto in the 1960s often have it above the classroom ceilings and over the gym. Bank branches, telephone buildings, parking garages and a few church additions from the same years can have it too.
Out in the counties it turns up in plant additions in Fulton and Oswego, in steel-frame stores in Auburn and Cortland, and in office wings attached to older brick mills in Utica and Rome. The common thread is a steel frame put up from the 1950s into the 1970s. Wood-frame houses rarely have fireproofing, though a house with a steel beam in the basement sometimes carries a sprayed coating on that one beam.
Most calls start when somebody needs to work above the ceiling. A tenant fit-out needs new ductwork, a sprinkler contractor needs to hang new mains, or an electrician needs to run conduit across the steel. Many HVAC installers, sprinkler fitters and electricians will not touch the space until the asbestos on the steel beams is out of their work path.
Sometimes the call comes after a ceiling tile is lifted and gray fluff drops out. If that happens, set the tile back in place, keep people out of that room, and send us photos from a distance. A small area like that is a job we take on its own, without waiting for a larger renovation to come together.
A price starts with the address and a few photos. If an outside firm has already done a survey or lab report on the building, send that too. If there is no report, we price the fireproofing as presumed asbestos-containing material, which is how most commercial owners start. The more we can see of the steel, the deck and what sits underneath, the tighter the range comes back.
Photos taken from a mechanical room, an access hatch or a spot where a ceiling tile is already missing are fine. Leave tiles in place. A shot of the floor plan or a fire escape map helps on larger buildings. We send a price within 1 hour, 7 AM to 9 PM ET. The phone number is (315) 810-9558 if you would rather call with the address.
The work area is sealed off from the rest of the building before any material comes down. In an office tower that is usually the suite or the floor, with corridors and neighboring tenants kept apart from it. In a warehouse it may be a set of bays. The material is removed from the steel and deck, bagged, and hauled to a permitted landfill. The work is done by our own DOL-certified crew.
A few beams over one office can take hours to a day. A full floor or a large warehouse ceiling runs longer, and the time depends on area, height and how hard the coating is. When the crew leaves, the steel is bare and the area is clean and ready for the next trade. We file the required state notices, and you receive the waste manifests for your records.
Most fireproofing work comes from commercial owners, property managers and general contractors with a renovation on the calendar. We also work for HVAC, sprinkler and electrical contractors who need a clear path through the ceiling, for buyers and sellers sorting out a commercial building before a sale, and for school districts and churches redoing an addition. Each one gets the same thing: the material out and the paperwork in hand.
Small jobs are welcome. One beam where a new duct needs to pass, one column getting a new enclosure, or one bay of deck under a leaking roof drain is a normal request. Larger floors are priced the same way, from the address, photos and a rough size. A general contractor bidding a fit-out can send drawings or ceiling photos and get a range back within the hour.
Once the old material is off, the steel usually needs new fireproofing to keep the building's fire rating, and that coating is applied by the fireproofing or drywall contractor on the project. Ducts, sprinkler mains and conduit go up on clean steel first. Then the ceiling grid and tile go back in, and the space is turned over to the tenant or the owner.
If the building or an addition is coming down instead, we also do demolition. Abatement and the teardown are one company and one schedule, with no handoff between two contractors and no gap while a second crew gets lined up. That matters most on steel-frame buildings, where the fireproofing has to come off the frame before the frame itself can come down.
Our office is at 4830 W Seneca Turnpike, Syracuse NY 13215. We work across Syracuse and Onondaga County, including Liverpool, Clay, Cicero, DeWitt, Camillus and Solvay, and in Oswego, Cayuga, Cortland, Madison, Oneida, Seneca, Wayne and Jefferson counties. We also take fireproofing jobs in the Rochester, Utica, Binghamton, Watertown and Elmira areas. Send the address and photos from anywhere in that range for a price.
The price depends on how many square feet of steel and deck are coated, how high it sits, and whether the space is open or crowded with racking, ductwork and occupied offices. Soft fluffy fireproofing comes off differently than a hard cement coating, and wet or delaminating material adds cleanup.
Send the address and a few photos. Estimate within 1 hour, 7 AM to 9 PM ET.