We remove asbestos cement board, transite panels, millboard and the gray sheets behind old stoves and boilers, plus soffit panels and corrugated sheets outside. Our crew works in houses, shops, schools, farms and commercial buildings across Syracuse and Upstate New York.
Price within 1 hour.
Asbestos cement board is a flat, hard sheet made of cement and asbestos fiber, sold under trade names like Transite and called cement board, fire board or asbestos board on the job. Sheets are usually gray or off-white, an eighth to a half inch thick, with a smooth or lightly textured face. They were screwed or nailed to studs, walls and framing from the 1920s through the 1970s.
Asbestos millboard is a softer cousin. It is grayish and lighter, and it feels a little like thick cardboard. A fingernail can dent it, and it frays at the edges. Millboard was used as a heat shield and inside old stoves and heaters. Because it breaks down more easily, damaged millboard should be left alone rather than pulled at or cut.
The classic spot is the asbestos sheet behind a stove or furnace: a gray panel on the wall or ceiling behind a wood stove, a coal stove converted to oil, or an old boiler, often mounted with a gap behind it for air. You see it in farmhouse kitchens in Pompey and Fabius, in basements of 1920s two-family houses in Eastwood and Tipperary Hill, and in garage workshops where someone ran a stove.
Asbestos wallboard also shows up as finished wall and ceiling surfaces. Boiler rooms, school shop rooms, church kitchens, and laundry or utility rooms in 1950s ranch houses in Clay and Camillus sometimes have full walls of it, painted over. Old electrical panel backs, fireproof closet linings and the underside of basement stairs are other places it turns up.
Outside, flat cement board was used for soffits, porch ceilings, gable infill and the panels under windows on 1950s and 1960s houses and commercial buildings. Asbestos soffit panels are common on postwar ranches in Liverpool, Mattydale and DeWitt, and on schools, motels and strip plazas from the same years. They are usually painted, which hides the gray color, and the edges are cut clean and tight.
Corrugated asbestos panels are the wavy gray sheets on barns, mill sheds, carports and industrial walls. They were common on farm buildings in Cayuga, Madison and Oneida counties and on factory additions in Oswego, Fulton and Utica. Many are still up, faded and streaked with moss, and some are cracked from age, hail or falling branches.
Board usually comes up because something next to it is changing. The old stove or boiler is going and the installer does not want to work around the heat shield. A kitchen or basement renovation needs the wall opened. A soffit is rotting and the gutter installer finds cement panels instead of wood. A buyer's report or an insurer flags the panel behind the stove. Common situations:
Cracked or broken board, and crumbling millboard in particular, should stay in place and not be drilled, cut or pried at. Take photos of the damage and of the full panel and send them over. Broken board is priced and removed the same way as intact board, with the debris picked up as part of the job.
Send the address and photos of each panel or wall. One wide shot shows where the board is and what surrounds it, and one close shot with a tape measure, a hand or a light switch in the frame shows thickness and condition. Give a rough size in plain terms: the panel is about four feet square, the wall is ten feet long, the soffit runs along the front and one side.
Tell us how it is attached if you can see it, whether screws, nails or glue, and whether anything is mounted on it. If there is a lab report, send it along. If there is not, the board is priced as presumed asbestos-containing material. A price comes back in 1 hour, 7 AM to 9 PM ET, by text or email, and our phone is (315) 810-9558.
The crew on site is our own and DOL-certified, and the required state notices are filed by us. The work area is sealed off from the rest of the building. Indoors, that is the room or the part of the basement where the board is, with doors and openings covered. Outdoors, the ground under the soffit or wall is covered and marked off. The board is taken down, bagged and hauled to a permitted landfill.
A single heat shield behind a stove is often done in hours. A full room of wallboard, a run of soffit around a house, or a barn wall of corrugated panels can take a day or a few days. When the crew leaves, the studs, framing or wall surface behind the board are exposed and clean, and you get the waste manifests.
Homeowners call before a stove or boiler swap or a kitchen remodel. Landlords call when a rental's utility room or basement is being redone between tenants. Stove installers, HVAC contractors, roofers, gutter crews and remodelers call when the board is in their way and they will not cut through it. Buyers and sellers call when a closing condition mentions it.
Farm owners call about corrugated barn walls and roofs. Property managers call about soffits across a row of townhouses or a strip plaza. General contractors and commercial owners call for boiler rooms, shop rooms and old mechanical spaces in schools and churches. Small jobs are welcome. One heat shield, one panel or one porch ceiling is a normal job for us.
With the board out, the next trade has a clean start. Stove installers put up a listed heat shield or wall protection for the new unit. Drywall crews close up the room. Roofers and gutter crews hang vented aluminum or vinyl soffit on the old framing. Farm owners can re-skin a barn wall in steel. The waste manifests show the old board went to a permitted landfill.
If the building is coming down, the board is the first step. We remove the asbestos cement panels and any other asbestos materials, then demolish the structure and haul it off. One company and one schedule covers both, which keeps things simple for a farm owner clearing an old barn or a developer clearing a lot.
Our office is at 4830 W Seneca Turnpike in Syracuse. We cover Onondaga County from Elbridge and Jordan to Manlius and Pompey, and we take cement board jobs in Oswego, Cayuga, Cortland, Madison, Oneida, Seneca, Wayne and Jefferson counties. We also work around Rochester, Utica, Binghamton, Watertown and Elmira, in the farm towns between them and in the lake communities along Oneida and Owasco.
The price depends on how much board there is, whether it is indoors or outside, and how high it sits, since soffits and gable panels need ladders or lifts. How the board is attached matters too: screwed sheets come off cleaner than glued ones, and cracked or crumbling millboard takes more care than solid panels.
Typical figures for common asbestos jobs in Central NY:
| Job | Typical cost |
|---|---|
| Smallest jobs: one pipe run, one section of duct, one room | From about $1,250 |
| Floor tile and mastic, one room | $1,500 to $4,500 |
| Pipe insulation | $2,000 to $8,000 |
| Ductwork or duct wrap | $2,000 to $8,000 |
Send the address and a few photos. Estimate within 1 hour, 7 AM to 9 PM ET.