Asbestos insulation covers steam pipes, wraps boilers and tanks, lines ductwork, and fills attics and walls. We remove every type from homes, rental properties, schools, churches, mills and commercial buildings across Syracuse and Central New York.
Price within 1 hour.
Asbestos was mixed into insulation because it held up to heat and did not burn. From the late 1800s through the 1970s it went into pipe covering, boiler jackets, duct wrap, tank insulation, and some attic and wall fill. Heating systems got the most of it. The older the boiler room, the more likely the insulation in it is original. Many buildings around Syracuse still carry the first heating plant's insulation, even after the boiler itself was swapped out.
Old insulation removal starts with sorting out which type you have, because each one sits in a different place and comes off a different way. The sections below describe each type briefly. If you are not sure what you are looking at, a few photos with something for scale usually tell us enough to price the job.
Pipe insulation is the most common. On steam and hot water lines it looks like a white or gray sleeve, often wrapped in canvas or painted cloth, and sometimes with a corrugated paper look called aircell. Elbows, tees and valves frequently have a hard, plaster-like mud packed around them. It runs along basement ceilings, through crawl spaces, and up inside walls to the radiators on every floor.
Boiler insulation is a hard white or gray coating troweled over older cast iron and steel boilers, sometimes in a shell several inches thick, sometimes as blocks held on with wire and finished with a cement skim. Tank insulation covers hot water storage tanks, old expansion tanks hung near the ceiling, and condensate or oil tanks in larger buildings. Boilers and tanks usually sit in the same room, next to each other.
Duct insulation shows up on gravity furnaces and early forced air systems. It can be a gray paper wrap on the outside of round ducts, a white tape at the seams, or a woven fabric collar where the duct meets the furnace. On commercial buildings it may be heavy board or blanket around large rectangular ducts running through a mechanical room or above a ceiling.
Attic insulation that can contain asbestos includes loose fill, vermiculite pebbles and some rock wool. Asbestos wall insulation is less common, but it is out there: loose fill that fell into balloon-frame walls from the attic, block cores filled with vermiculite, and old batts. Asbestos batt paper backing is worth a mention. Some older batts had a paper or felt facing, and in some lab reports it is the facing that comes back positive rather than the fiber inside.
A 1920s two-family on the Northside with a steam boiler is the textbook case: pipe covering across the whole basement, a jacketed boiler, and risers running up through both units. A 1950s ranch in Mattydale or Camillus with a gravity furnace usually has duct wrap and a taped plenum. A cape in Eastwood with a knee-wall attic may have loose fill above the upstairs bedrooms and batts behind the knee walls.
Larger buildings have more of it. Schools, churches and parish halls with old steam plants have boiler rooms full of pipe and tank insulation. Downtown storefront buildings in Syracuse, Auburn and Oswego carry pipe covering through basements and ceilings. Old mills in the canal and river towns, and farmhouses with additions built over a century, often have several types of insulation in the same building, each from a different decade.
Most asbestos insulation abatement starts with another project. Plumbers, heating contractors and HVAC installers often will not cut or move pipes and ducts that are still wrapped. A buyer's home inspection flags white wrap in the basement. An insurer or lender wants it handled before the closing. A building owner is planning a renovation that runs right through the mechanical room.
Damaged insulation that is hanging, crumbling or soaked should be left alone and not disturbed until it is removed. Keep people and pets out of that area, shut the door if there is one, and do not try to tape or patch it. Send photos of what you see, wide and close, and we will price it the same way as any other job.
We do not test, sample, inspect or survey. If there is already a lab report or survey on the building, send it with the photos. If not, the insulation is priced as presumed asbestos-containing material. A price comes back in 1 hour once we have the address and photos, any time from 7 AM to 9 PM ET. Photos can also be texted to (315) 810-9558. What helps most depends on the type:
The area where the insulation is gets sealed off from the rest of the building. In a house, that might be the boiler room, the whole basement, or the attic. In a larger building it might be one mechanical room or one floor. Our DOL-certified crew removes the insulation, bags it, and it is hauled to a permitted landfill. We file the required state notices before the work starts.
Time on site runs from a few hours for a single pipe run or one fitting, to about a day for a typical basement, to a few days for a full boiler room or a large attic. When the crew leaves, the pipes, ducts and boiler are bare and the area is ready for the next trade. You keep the waste manifests showing where the material went.
Homeowners replacing a boiler or finishing a basement. Landlords with older multi-family buildings. Buyers and sellers working through an inspection. Plumbers and HVAC contractors who need pipes and ducts bare before their install. Property managers, general contractors and commercial owners with mechanical rooms, schools, churches and storefronts. Small jobs are welcome: one pipe, one section of duct, one room, one attic.
When the insulation is gone, the work that was waiting can go ahead: a new high-efficiency boiler, a furnace and new ductwork, a heat pump, new pipe insulation, or a finished basement ceiling. If the building is being taken down instead, we also do demolition, so the abatement and the teardown are one company on one schedule.
We are based at 4830 W Seneca Turnpike, Syracuse NY 13215. The crew works throughout Syracuse and Onondaga County, and in Oswego, Cayuga, Cortland, Madison, Oneida, Seneca, Wayne and Jefferson counties. We also take insulation jobs in the Rochester, Utica, Binghamton, Watertown and Elmira areas. From a single fitting in a house basement to a full boiler room in a church, the first step is the same: send the address and photos.
Insulation pricing depends on the type and the amount: feet of pipe, number of fittings, size of the boiler or tank, length of duct, or square feet of attic. Height, access and condition matter, since wet or crumbling insulation takes longer than intact covering. How it is attached, whether a thin wrap or a thick troweled shell, also moves the price.
| Job | Typical cost |
|---|---|
| Pipe insulation | $2,000 to $8,000 |
| Ductwork or duct wrap | $2,000 to $8,000 |
| Vermiculite attic | $9 per square foot of attic, $7,500 minimum |
| Smallest jobs: one pipe run, one section of duct, one room | From about $1,250 |
Send the address and a few photos. Estimate within 1 hour, 7 AM to 9 PM ET.