Steam and hot water lines in older buildings were wrapped in air cell, block lagging and hard plaster at the elbows. We remove asbestos pipe insulation from houses, two-families, apartment blocks, churches, schools and mills across Central New York.
Price within 1 hour.
From the early 1900s through the 1970s, heating pipes were insulated to keep the heat in the line until it reached the radiators. The most familiar type in houses is air cell insulation: a white or gray corrugated paper wrap that looks like cardboard when you see it from the cut end. It usually has a canvas or paper jacket over it, sometimes painted, sometimes held with metal bands.
On bigger steam lines the covering is often a hard, chalky half-round section called lagging, also known as pipe covering or mag block. Elbows, tees and valves were finished with a plaster-like cement packed by hand around the fitting, so asbestos elbow and fitting insulation often looks lumpy and different from the straight runs next to it. Any of these products can contain asbestos, and the age of the system is the first clue.
The classic case is a 1920s two-family in Tipperary Hill, the Westside, Outer Comstock or Eastwood with a steam or hot water boiler in the basement. The mains run along the joists in a loop, risers climb to the second-floor flat, and every inch is wrapped. Farmhouses in Lafayette, Pompey and Tully that were converted to central heat in the 1930s or 1940s often have the same layout with longer runs out to additions.
In larger buildings asbestos steam pipe insulation runs through tunnels, crawl spaces and pipe chases. Old schools, church halls, apartment blocks along James Street and the mills in Oswego, Fulton and Little Falls can have hundreds of feet of lagging overhead. Storefronts with apartments above often have a mix of old and new pipe, where a plumber replaced some lines and left the original covering on the rest.
A boiler conversion is the most common reason. The old steam boiler is coming out, the mains are being replaced with new hot water or the system is going to forced air, and the plumber will not cut through wrapped pipe. Many plumbing and heating contractors refuse to work near the material at all, so the asbestos pipe wrap removal has to be done and finished before they return.
Other calls follow a home inspection report that notes white wrap on basement pipes, or a buyer whose lender or insurer wants it gone. A burst pipe in a cold snap can split the jacket and spill crumbled wrap onto the floor. Landlords call before a tenant moves into a basement unit, and owners call before finishing a basement or opening a wall. Wrap that is torn or falling apart should be left where it is and not handled.
We do not take samples or send anything to a lab. If someone has already tested the material, include that lab report or survey when you send photos. If there is no report, we price the pipe insulation as presumed asbestos-containing. Owners replacing a heating system usually handle it that way, since the insulation is coming off regardless of the result.
A good set of photos shows the boiler end of the system, a long view down each main, and close shots of a few elbows and any damaged spots. Hold a tape measure across one pipe so we can see the outside diameter of the wrap. Send these and we will reply with a price within 1 hour, 7 AM to 9 PM ET.
One short run or a single elbow can be done in a few hours. A full basement of mains and risers in a two-family is often about a day. Long runs in a school tunnel or mill building take a few days or more. Our own DOL-certified crew seals the work area off from the rest of the building. People upstairs can usually stay, but the basement or pipe area is closed until we finish.
The insulation is removed, bagged and hauled to a permitted landfill. We can leave the bare pipe in place for the plumber, or cut and remove the pipe along with its wrap if the lines are being replaced. We file the required state notices. When the crew leaves, you have clean pipe or an empty run, and you get copies of the waste manifests for your records.
Homeowners call when the boiler is being replaced or the basement is being finished. Landlords with older multi-family buildings in Syracuse, Auburn, Cortland and Rome call between tenants or when an insurer asks about the pipes. Buyers and sellers use us to clear an inspection item before a closing date. We take small jobs: one pipe, one elbow, one closet riser.
Plumbers and heating contractors send customers our way so the install can move forward. Property managers bring us in for apartment buildings and offices where a line has failed. General contractors need the pipes cleared before demolition inside a renovation, and commercial owners call for schools, churches, warehouses and mill buildings where steam lines have been sitting unused for years.
With the old lagging gone, the plumber can cut in new piping, install a modern boiler or tie the building into a new heating system. Basement ceilings can be framed and covered. In a steam to hot water conversion, the old mains often come out entirely and new copper or PEX goes in along the same path.
When the building is being demolished, we handle that too. The pipe insulation and any other asbestos materials come out first, and our demolition work follows on one schedule under one company. That works for a barn with an old boiler room, a closed school wing or a house on a lot being cleared.
We work out of 4830 W Seneca Turnpike in Syracuse and cover Syracuse and all of Onondaga County, from Baldwinsville and Liverpool to Jamesville, Onondaga Hill and Solvay. We also work in Oswego, Cayuga, Cortland, Madison, Oneida, Seneca, Wayne and Jefferson counties, and the Rochester, Utica, Binghamton, Watertown and Elmira areas. Send the address and photos, or call (315) 810-9558, and get a price in 1 hour.
Pipe jobs are priced mostly on the total length of wrapped line and the number of covered elbows, valves and tees, since fittings take longer than straight runs. Pipes that are high overhead, inside walls, or in a tight crawl space take more time than lines hanging along an open basement ceiling. Wrap that is already falling apart adds cleanup of the floor and nearby surfaces.
| Job | Typical cost |
|---|---|
| Pipe insulation | $2,000 to $8,000 |
| Smallest jobs: one pipe run, one section of duct, one room | From about $1,250 |
Send the address and a few photos. Estimate within 1 hour, 7 AM to 9 PM ET.